NC-35+75A
Model NC-35 NC-45 NC-60 NC-68
Table size (mm) 700x400 800x450 1000x600 1700x800
Worktank(L)
Inner(W)
Dimension(H)		 1070 
630 
400		 1170 
630 
400		 1700 
1000 
650		 2500 
1100 
750
X axis travel 420 500 800 1500
Y axis travel 320 400 600 600
Z axis NC(Model) 180(Servo)+250(Rapid) 180(Servo)+250(Rapid) 400 450
Table T-solt
(NumberxWidth)		 3x14 4x14 6x18 6x18
Dielectric tank
capacity(L)		 450 450 1250 2200
POWER SUPPLY UNIT:
Model Max. normal
Output current
(AMP)		 Max. machining
Speed(mm³/MIN)		 Min. Electrode
Wear ratio
(Under)		 Best surface
Roughness
(µ/RMAX)		 Power
Consumption
(KVA)
30A 30 250 0.3% 0.3-0.5 3
50A 50 350 0.3% 0.3-0.5 4.5
75A 75 400 0.3% 0.3-0.5 7
100A 100 600 0.5% 0.3-0.5 10
150A 150 900 0.5% 0.3-0.5 15
200A 200 1300 0.5% 0.3-0.5 20
 

FAST   E. D. M. DRILLER
Model V-200D V-350D NC-350D
Worktable size 210 x 460mm 300 x 600mm 300 x 600mm
X. Y. Travel 300 x 200mm 350 x 250m 340 x 240mm(AC servo)
Z 1 Axis servo travel 350mm 340mm 340mm
Z 2 Axis AC motor rapid ------ 200mm 200mm
Guide travel 150mm 150mm 150mm
Workpiece load 300kgs 400kgs 400kgs
Electrode size Ø 0.2 to 3.0mm Ø 0.2 to 3.0mm Ø 0.2 to 3.0mm
Maximum electrode length 400mm 400mm 400mm
Ram platen to worktable 100 - 250mm 5 - 355mm 5 - 355mm
Dielectric fluid Distilled Water
Dielectric tank 25 liters x 2pcs 25 liters x 2pcs 25 liters x 2pcs
POWER SUPPLY UNIT:
Maximum current selection 30 AMPS
Peak current selection 9 steps
On-time settings 9 steps
Off-time settings 9 steps
C-Box settings 9 steps
Gap voltage selection 3 steps
Power consumption 3.5KVA

Next
|| Rapido Machine Center||Vertical Machining Center ||
|| CNC Bed Mill Center || Conventional Milling Machine ||
||  NC E.D.M./Driller E.D.M. || ZNC/Conventional E.D.M. || @Message || Home ||